Ricoh R-C4 Service Manual page 241

21 July 2006
5828 Network Setting
5828 50 1284 Compatibility
(Centro)
5828 52 ECP (Centro)
5828 65 Job Spooling
5828 66 Job Spool Clear: Start
Time
5828 69 Job Spool Protocol
5828 77 IPv4 DNS Server 2
5828 78 IPv4 DNS Server 3
5828 79 Domain Name
(Ethernet)
5828 84 Setting List PrintPrint
Settings List
5828 90 TELNET Operation
SettingsTELNET
(0:OFF 1:ON)
5828 91 Web Operation
(0:OFF 1:ON)
Enables and disables bi-directional communication on
the parallel connection between the machine and a
computer.
[0~1/1]
0:Off
1: On
Disables and enables the ECP feature (1284 Mode) for
data transfer.
[0~1/1]
0: Disabled
1: Enabled
Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
This SP determines whether the job interrupted at
power off is resumed at the next power on. This SP
operates only when SP5828 065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
This SP etermines whether job spooling is enabled or
dispabled for each protocol. This is a 8-bit setting.
0 LPR
1 FTP (Not Used)
2 IPP
3 SMB
Sets the IPv4 address for a DNS server. This address
can be used among devices that have IPv4 devices
(Ethernet, IPv4 Over 1394, IEEE 802.11b, etc.)
Note: IPv4 Over 1394 applies to the B205/B209 only.
The D007/D008 does not support IEEE 1394.
Prints a list of the NCS parameter settings.
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0~1/1]
0: Disable
1: Enable
Disables or enables the Web operation.
[0~1/1]
0: Disable
1: Enable
5-53
SERVICE PROGRAM MODE
4 BMLinks (Japan Only)
5 DIPRINT
6 Reserved (Not Used)
7 Reserved (Not Used)