Table of Contents
Advertisement
®
OBID i-scan
3.4. CFG3: RF-Interface
The parameters of the CFG3 configuration block contain general Transponder driver and Reader set-
tings.
Byte
0
Contents
TAG-DRV
Default
0x004F
Byte
7
Contents
0x00
Default
1
TAG-DRV
:
Defines the Transponder types that are operated by the Reader.
Byte:
Bit:
Driver
b0:
Driver for the Transponder type is inactive
b1:
Driver for the Transponder type is active
.A:
.B:
.D:
.G:
.H:
On principle, only those Transponder drivers should be active that are used in the
actual application. Thus, the reaction time of the Reader for Transponder read- /
write-operations is reduced and the danger of a parasitic Transponder access is
minimized.
Note:
For the support of the I-Code EPC and UID Transponder on the reader ID
ISC.MR/PR/PRH100 and ID ISC.M02 is a special Firmware version necessary.
This version supports the I-Code EPC and UID Transponder only.
The I-Code EPC and UID Firmware must be released with the command "Set
Firmware Upgrade" first. For this you have to use the demo program ID
ISOStart and the Upgrade Code must be ordered by Feig Electronic.
1
A plausibility check is performed by writing this parameter to the Reader. If an error occurs the Reader an-
swers with STATUS = 0x11.
FEIG ELECTRONIC GmbH
System-Manual
1
2
1
0x00
8
9
0x00
0x00
0
15
14
13
12
11
0
0
0
0
0
Driver for I-Code 1
Driver for Tag-it HF (not available with ID ISC.M02, ID ISC.MR/PR101)
Driver for ISO15693
Driver for I-Code EPC (must be released first)
Driver for I-Code UID (must be released first)
3
0x00
10
0x00
10
9
8
7
0
0
0
.H
Page 24 of 118
ID ISC.MR/PR/PRH100/101-A
4
5
0x00
0x00
11
12
0x00
0x00
1
6
5
4
3
.G
0
0
.D
H01000-5e-ID-B.doc
6
0x00
13
0x00
2
1
0
0
.B
.A
Advertisement
Table of Contents
