0Xa0] Read Config Block - Feig Electronic OBID i-scan ID ISC.MR100 Manual

®
OBID i-scan

6.1.14. [0xA0] Read Config Block

This command reads one config block of the i-scan memory model (see
Code 1 Transponders).
REQUEST-DATA
4
0xA0 MODE
RESPONSE-DATA
5...8
CB
MODE:
Bit:
Function
ADR:
b001
UID:
Read-only serial number of the Transponder.
CB-ADR:
Address of the config block to be read from the Transponder.
CB:
Requested config block.
Note:
• This command is only available for I-Code 1 and Tag-it HF Transponders.
• The command is not available if the Reader is set to original I-Code Memory Mode.
(see 3.5. CFG4: Transponder
To read the Config Block 0,1,2 can now be done with Read Multiple Blocks [0x23] on the
original I-Code Address 2,3,4.
FEIG ELECTRONIC GmbH
System-Manual
5 6...13
UID
7 6
0 0
addressed
Parameters, I-Code-Mode).
14
CB-ADR
5 4
0 0
Page 70 of 118
ID ISC.MR/PR/PRH100/101-A
ANNEX G: Memory Model I-
3 2 1
0 ADR
H01000-5e-ID-B.doc
0