0Xa2] Get Log Status - Feig Electronic OBID i-scan ID ISC.MR100 Manual

®
OBID i-scan

8.2.3. [0xA2] Get Log Status

This command reads the status flags for the logging of the measurement values.
REQUEST-DATA
5
0xA2 MODE
RESPONSE-DATA (STATUS = 0x95)
5
ISO-ERROR
RESPONSE-DATA
5
Logflags Logpointer
MODE:
Bit:
Function
ADR:
UID:
Read-only serial no. of the transponder. The UID is required only in the addressed mode.
ISO-ERROR:
ISO error code of transponder response. This byte is only available if STATUS = 0x95.
Logflags: The type of measurement.
Logpointer: Pointer of the next measurement value
LogLimitLo: Lower limit for measurement value
LogLimitHi: Higher limit for measurement value
Logperiode: Range of the measure.
Timerticks: Defines how many times the measurement interval runs off.
FEIG ELECTRONIC GmbH
System-Manual
6 (7-14)
UID
6 7-8
LogLimitLo
7 6
- -
ADR
b000 non-addressed
b001 addressed
b010 selected
9-10 11-12
LogLimitHi Logperiode
5 4
- -
Page 80 of 118
ID ISC.MR/PR/PRH100/101-A
13-14
Timerticks
3 2 1
- ADR
H01000-5e-ID-B.doc
0