Table of Contents
Advertisement
®
OBID i-scan
6.1.15. [0xA1] Write Config Block
This command writes one config block of the i-scan memory model (see
Code 1
Transponders).
REQUEST-DATA
4
0xA1
MODE
MODE:
Bit:
Function
ADR:
b001
UID:
Read-only serial number of the Transponder.
CB-ADR:
Address of the config block to be read from the Transponder.
CB:
Config block to be written to the Transponder.
Note:
• This command is only available for I-Code 1 and Tag-it HF Transponders.
• The command is not available if the Reader is set to original I-Code Memory Model.
(see
3.5. CFG4: Transponder
To write the Config Block 0,1,2 can now be done with Write Multiple Blocks [0x24] on the
original I-Code Address 2,3,4.
• Example for write config block 0 of a Tag-it HF Transponder (Config 0 activated protective
functions of the Transponder ("1": r/w, "0": ro))
• The Reader only evaluates the bits which are "0" in the LSB (Byte 0)
3
b xxxx xxxx
b xxxx xxxx
and tries to lock the blocks 0,2,5 and 6. If one block is already locked, the status will be set
to 0x00.
When using ISO15693 Transponders the command
be used.
FEIG ELECTRONIC GmbH
System-Manual
5
6...13
UID
7
6
0
0
addressed
Parameters, I-Code-Mode).
2
1
b xxxx xxxx
14
15...18
CB-ADR
CB
5
4
0
0
0
b 1001 1010
6.1.3. [0x22] Lock Multiple Blocks
Page 71 of 118
ID ISC.MR/PR/PRH100/101-A
ANNEX G: Memory Model I-
3
2
1
0
ADR
H01000-5e-ID-B.doc
0
should
Advertisement
Table of Contents
