0Xa1] Set Log - Feig Electronic OBID i-scan ID ISC.MR100 Manual

®
OBID i-scan

8.2.2. [0xA1] Set Log

This command starts the recording of the temperature of the KSW - TempSens.
REQUEST-DATA
5
0xA1 MODE
RESPONSE-DATA (STATUS = 0x95)
5
ISO-ERROR
MODE:
Bit:
Function
ADR:
ISO-ERROR: (only ISO transponders)
ISO error code of transponder response. This byte is only available if STATUS = 0x95.
UID:
Read-only serial no. of the transponder. The UID is required only in the addressed mode.
Logflags: The type of measurement.
Logpointer: Pointer of the next measurement value.
Logperiode: Range of the measure. .
LogLimitLo: Lower limit for measurement value
LogLimitHi: Higher limit for measurement value
FEIG ELECTRONIC GmbH
System-Manual
6 (7 - 14)
UID
12-13 (19-20)
LogLimitLo
7 6
- -
ADR
b000 non-addressed
b001 addressed
b010 selected
8 (15) 9 (16)
Logflags Logpointer
14-15 (21-22)
LogLimitHi
5 4
- -
Page 79 of 118
ID ISC.MR/PR/PRH100/101-A
10-11 (17-18)
Logperiode
3 2 1
- ADR
H01000-5e-ID-B.doc
0