Error-Code For Iso15693 Transponders - Feig Electronic OBID i-scan ID ISC.MR100 Manual

®
OBID i-scan
Hex-value
0x10 EEPROM-failure:
•
The EEPROM of the Reader is not able to be written on.
•
Before writing onto the EEPROM a faulty checksum of parameters has been detected.
0x11 Parameter-Range-Error:
•
The value range of the parameters was exceeded.
0x17
Firmware activation required:
•
The firmware must be activated first using ISOStart demo program and the command "Set
Firmware Upgrade". The update code must be ordered by Feig Electronic.
1. Read the Device-ID using the command [0x66] Firmware version (Mode 0x80)
2. Send the Device-ID and the serial number of the reader to Feig Electronic
3. Write the upgrade code into the reader using the command [0x5F] Set Firmware Up-
date
Hex-value
0x80 Unknown Command:
•
The Reader does not support the selected function.
0x81 Length-Error:
•
Protocol is too short or too long
0x82
Command not available:
•
0x83
RF communication error:
This error indicates that there is an error in communication between the Transponder
and the Reader. Reason for this can be:
•
The collision handling algorithm was not continued until no collision is detected, reasons
for the break:
- TR-RESPOSE-TIME in CFG1: Interface is to short
0x94
More Data:
•
There are more Transponder data sets requested than the response protocol can transfer
at once.
0x95 ISO 15693 Error:
•
An additional error code for ISO15693 Transponders is sent with response data.

Error-Code for ISO15693 Transponders

Hex-value
0x01 The command is not supported, i.e. the request code is not recognized
0x02 The command is not recognized, for example: a format error occurred
0x03 The option is not supported
0x0F Unknown error
0x10 The specified block is not available (doesn't exist)
0x11 The specified block is already locked and thus cannot be locked again
0x12 The specified block is locked and its content cannot be changed
0x13 The specified block was not successfully programmed
FEIG ELECTRONIC GmbH
System-Manual
Parameter Status
Interface Status
Response error code definition
Page 109 of 118
ID ISC.MR/PR/PRH100/101-A
H01000-5e-ID-B.doc