Feig Electronic OBID i-scan ID ISC.MR100 Manual page 2

®
OBID i-scan
© Copyright 2002-2003 by
FEIG ELECTRONIC GmbH
Lange Strasse 4
D-35781 Weilburg-Waldhausen
Tel.: +49 6471 3109-0
http://www.feig.de
Edition: MD/05/03/08 - h01000-5e-id-b_mit m02.doc
With the edition of this manual, all previous editions become void. Indications made in this manual may be changed without
previous notice.
Copying of this document, and giving it to others and the use or communication of the contents thereof are forbidden without
express authority. Offenders are liable to the payment of damages. All rights are reserved in the event of the grant of a patent
or the registration of a utility model or design.
Composition of the information in this manual has been done to the best of our knowledge. FEIG ELECTRONIC GmbH does
not guarantee the correctness and completeness of the details given in this manual and may not be held liable for damages
ensuing from incorrect or incomplete information. Since, despite all our efforts, errors may not be completely avoided, we are
always grateful for your useful tips.
The installation instructions given in this manual are based on advantageous boundary conditions. FEIG ELECTRONIC
GmbH does not give any guarantee promise for perfect function in cross environments.
FEIG ELECTRONIC GmbH assumes no responsibility for the use of any information contained in this manual and makes no
representation that they free of patent infringement. FEIG ELECTRONIC GmbH does not convey any license under its patent
rights nor the rights of others.
OBID ® is registered trademark of FEIG ELECTRONIC GmbH.
OBID i-scan ® is registered trademark of FEIG ELECTRONIC GmbH.
I-Code ® is registered trademarks of Philips Electronics N.V.
Tag-it is a registered trademark of Texas Instruments Incorporated
TM
• If bits within one byte are filled with "-", these bit spaces are reserved for future extensions or for internal
testing- and manufacturing-functions. These bit spaces must not be changed, as this may cause faulty op-
eration of the Reader.
• The following figure formats are used:
0...9: for decimal figures
0x00...0xFF: for hexadecimal figures,
b0...1 for binary figures.
•
The hexadecimal value in brackets "[ ]" indicates a control byte (command).
FEIG ELECTRONIC GmbH
System-Manual
General information's regarding this manual
Page 2 of 118
Note
ID ISC.MR/PR/PRH100/101-A
H01000-5e-ID-B.doc