Table of Contents
Advertisement
®
OBID i-scan
Annex J: Differences between USB- and SCI-Reader
RS232/485-Interface (SCI)
•
Firmware
Update is possible via
Update
Hardware- or Software
Flash-Loader. The standard
RS232/485 Interface can be
used
After the Update the LED's
flashes alternating
A second CPU-Reset is
necessary.
•
Scan Mode
In the scan mode the data
will be transferred via the
RS232/485-Interface direct
to the PC-Application or e.g.
to a Terminal Program.
•
The maximum number of
signs is limited to 128Byte.
Not applica-
ble protocols
•
Protocols
According to this system
manual H01000-xe-ID-B.pdf
•
Connection
Connection via RS232 is
to a PDA
possible
FEIG ELECTRONIC GmbH
System-Manual
•
The Update is possible via the USB-Interface.
•
There are two Firmware files necessary:
1. Reader Firmware
2. USB-Controller Firmware
•
The reader firmware can be updated using the
"OBIDFirmwareUpdateTool".
•
The USB-Controller can be updated using a
software tool.
•
In scan mode the reader works like a keyboard.
That means the data will be send direct in the
application where the cursor is located
•
The maximum number of signs is limited to:
ASCII: 80 signs (without SN)
special character: 53 (without SN)
Hex: 40 signs (without SN)
•
Baud rate Detection
•
Different protocol frame.
Communication is only possible via
FEUSB.DLL.
•
Connection via USB-Interface is not possible.
Because of the reader and the PDA works as a
USB-Slave
Page 116 of 118
ID ISC.MR/PR/PRH100/101-A
USB-Interface
ID ISC.MR/PR101
H01000-5e-ID-B.doc
Advertisement
Table of Contents
