0X18] Destroy (Only I-Code Epc/Uid Transponders) - Feig Electronic OBID i-scan ID ISC.MR100 Manual

®
OBID i-scan

7.2. [0x18] Destroy (only I-Code EPC/UID Transponders)

This command will render the I-Code EPC/UID Transponder permanently unable to give any replies.
Host → Reader (TYPE – I-Code EPC)
1
0x15 COM-ADR
Host → Reader (TYPE – I-Code UID)
1
0x1C COM-ADR
Host ← Reader
1
6 COM-ADR
MODE:
Bit:
Function
TYPE:
b000
b001
EPC:
12 Byte I-Code EPC Data (electronic product code)
If the I-Code EPC data has only a length of 8 Byte, the I-Code EPC must be written left-
justified (Byte 5-12). The last 4 Bytes will be ignored.
IDD:
19 Byte IDD Data of I-Code UID
Password:
The password is of length 24 bits and must match with the content which was previously
written into the relevant section of the I-Code EPC/UID memory.
Notes:
• Only one Transponder may be in the RF-field. If more than one transponder in the field the
reader returns with status = [0x83] (RF Communication Error.)
• If the I-Code EPC doesn't match, the reader also answers with status = [0x83].
• If the command was not successfully (reader may continue read the I-Code EPC), the reader
answers with status = [0x03].
FEIG ELECTRONIC GmbH
System-Manual
2 3
0x18
2 3
0x18
2 3
0x18
7 6 5
0 0 0
I-Code EPC
I-Code UID
Page 73 of 118
4 5...16
Mode EPC
4 5...23
Mode IDD
4 5...6
STATUS CRC16
4 3
0 0
ID ISC.MR/PR/PRH100/101-A
17...19 20...21
Password CRC16
24...26 27...28
Password CRC16
2 1
TYPE
H01000-5e-ID-B.doc
0