Feig Electronic OBID i-scan ID ISC.MR100 Manual page 12

®
OBID i-scan
Selected:
In this mode the Reader communicates only with the one, selected Transponder.
Before reading or writing data in selected mode, the UID of the Transponder must be known.
This is executed by sending at first the protocol
Transponder must be selected with the select command (see:
must include its UID.
The following chart will show the necessary steps for the communication with a Transponder
in selected mode:
Host (Terminal / PC / ....)
Inventory
to get the UID
select Transponder with UID
read data
write data
FEIG ELECTRONIC GmbH
System-Manual
"6.1.1. [0x01]
→
Transponder in antenna field ?
Yes
←
status /
number of Trans-
ponders / UID
←
→
Transponder with the
correct UID in antenna field ?
Yes
←
status /
Transponder read
data
←
→
selected Transponder in antenna field ?
Yes
←
status /
Transponder read
data
←
→
selected Transponder in antenna field ?
Yes
←
OK status
←
Page 12 of 118
ID ISC.MR/PR/PRH100/101-A
Inventory". In a second step the
6.1.6. [0x25] Select) which
Reader
No
status =
no Transponder
No
status =
no Transponder
in Reader field
No
status =
no Transponder
in Reader field
No
status =
no Transponder
in Reader field
H01000-5e-ID-B.doc