Item
Description
1
1
Health LED
2
Power On/Standby button and
system power LED
1
3
NIC status LED
1
4
UID button/LED
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
3
Facility power is not present, the power cord is not attached, no power supplies are installed, power supply failure has occurred, or the
power button cable is disconnected.
Status
•
Solid green = Normal
•
Flashing green (1 Hz/cycle per sec) = iLO is rebooting
•
Flashing amber = System degraded
•
Flashing red (1 Hz/cycle per sec) = System critical
•
Solid green = System on
1
•
Flashing green (1 Hz/cycle per sec) = Performing power on
sequence
•
Solid amber = System in standby
•
Off = No power present
•
Solid green = Link to network
•
Flashing green (1 Hz/cycle per sec) = Network active
•
Off = No network activity
•
Solid blue = Activated
•
Flashing blue:
◦
1 Hz/cycle per sec = Remote management or firmware
upgrade in progress
◦
4 Hz/cycle per sec = iLO manual reboot sequence
initiated
◦
8 Hz/cycle per sec = iLO manual reboot sequence in
progress
•
Off = Deactivated
2
3
Component identification
12