Table of Contents
Advertisement
4. Proceed to Preparing the server for operation.
Preparing the server for operation
Procedure
1. Install any options or cables previously removed to access the TPM connector.
2. Do one of the following:
•
Install the air baffle.
•
Perform steps 9–13 of "Installing a midplane 4LFF SAS/SATA drive cage".
3. Install the access panel.
4. Install the server into the rack.
5. Connect each power cord to the server.
6. Connect each power cord to the power source.
7. Power up the server.
Enabling the Trusted Platform Module
When enabling the Trusted Platform module, observe the following guidelines:
•
By default, the Trusted Platform Module is enabled as TPM 2.0 when the server is powered on after installing it.
•
In UEFI Boot Mode, the Trusted Platform Module can be configured to operate as TPM 2.0 (default) or TPM 1.2.
•
In Legacy Boot Mode, the Trusted Platform Module configuration can be changed between TPM 1.2 and TPM 2.0
(default), but only TPM 1.2 operation is supported.
Enabling the Trusted Platform Module as TPM 2.0
Hardware options installation
141
Advertisement
Table of Contents
