Connecting Cables - Cisco 1120 Installation Manual

Chapter 3 Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2
Figure 3-6
Carefully place the component's mounting studs in the mounting channels on the slide rails. Allow the
Step 3
component mounting studs to fully seat in the mounting channels.
The component release levers (one on each slide rail) pivot to lock when the studs are fully engaged in
the mounting channels, and then to release the studs when you press the release. Ensure that the
component release levers are in the locked position.
Step 4 Press and hold the left and right slide extension release levers, and slowly slide the component and the
slide rails into the fully retracted position.

Connecting Cables

This section describes how to connect your CSACS 1120 Series appliance to the network and the
appliance console. This section includes:
•
•
•
•
Figure 3-7
The following table describes the callouts in
.
1
2
3
OL-19455-01
Aligning the Slide Rail with the Mounting Studs
Connecting the Network Interface
Connecting the Console, page 3-11
Connecting the Keyboard and Video Monitor, page 3-11
Cable Management, page 3-12
CSACS 1120 Series Appliance Rear View
1
AC power receptacle
PS/2 connector (video monitor)
PS/2 connector (keyboard)
2 4 7 8
3 5 6
Figure 3-7.
7 NIC 2 port LED (activity)
8 NIC 2 port LED (link)
9
Two USB 2.0 ports
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
Connecting Cables
10 11
9
3-9