Restoring Acs Data From The Serial Console - Cisco 1120 Installation Manual

Working with System Data
Step 9 If you entered
then press Enter.
Result: The console displays:
Backing up now . . .
All running services will be stopped and restarted automatically.
Are you sure you want to proceed? <Y or N>
To proceed, enter
Step 10
Result: ACS exports the backup file to the specified location and displays messages regarding the
progress of the back up.
When the backup process is completed, the console displays:
Transferring xxx completed.
The system prompt reappears.

Restoring ACS Data from the Serial Console

This section details how to use the serial console to restore ACS data from an FTP server after you
perform a back up. For more information on backing up ACS data, see
Serial
You typically perform this procedure in the web interface.
Note
Before You Begin
You must have the FTP server address and pathname, as well as the proper credentials for writing to the
FTP server (username and password). You also need the name of the backup file and, the decryption
password, if the backup was encrypted.
This procedure interrupts the use of the ACS for AAA services.
Caution
Caution This procedure overwrites current system data and replaces it with the backup data.
To restore ACS data from an FTP server:
Log in to the CSACS 1120. For more information, see
Step 1
Console.
At the system prompt, enter
Step 2
Tip
At the
Step 3
hostname, and press Enter.
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
4-14
to encrypt the backup file, at the
Y
and press Enter.
Y
Console.
restore
You can enter the following parameters after the command or in response to subsequent prompts:
[server] [username] [filepath]
Enter FTP Server Hostname or IP Address:
Chapter 4 Administering the Cisco 1120 Secure Access Control Server
Encryption Password:
Logging In to the CSACS 1120 from a Serial
, and press Enter.
prompt, enter the FTP server IP address or
prompt, enter a password and
Backing Up ACS Data from the
OL-19455-01