Configuring Csacs 1120 - Cisco 1120 Installation Manual

Initial Configuration
Tip See
Step 3 Set your terminal emulation communication software to operate with the following settings:
Note CSACS 1120 works with only a baud rate of 9600. CSACS 1120 does not support a baud rate of 115200
which other appliances use.
•
•
•
•
•
Result: The

Configuring CSACS 1120

You must configure the CSACS 1120 when you boot the system for the first time and whenever you
re-image the system. For more information on re-imaging the system, see
Table 3-2
Table 3-2
Task
Remote Agent configuration
System Configuration
ACS Back up
ACS Restore
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
3-16
Figure 1-4 for the location of the power switch on CSACS 1120.
Baud = 9600
Databits = 8
Stops = 1
Flow control = None
Terminal emulation type = ANSI
: prompt appears.
login
lists the essential configuration tasks that are unique to SE.
SE Configuration Tasks
Chapter 3 Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2
Available Resources
On Cisco.com:
http://www.cisco.com/en/US/docs/net_mgmt/
cisco_secure_access_control_server_for_windows/4.2/
user/guide/NetCfg.html#wp386216
On Cisco.com:
http://www.cisco.com/en/US/docs/net_mgmt/
cisco_secure_access_control_server_for_windows/4.2/
user/guide/SCBasic.html
On Cisco.com:
http://www.cisco.com/en/US/docs/net_mgmt/
cisco_secure_access_control_server_for_windows/4.2/
user/guide/SCBasic.html#wp222373
On Cisco.com:
http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_ac
cess_control_server_for_windows/4.2/user/guide/SCBasic.ht
ml#wp330795
Upgrade Scenarios.
OL-19455-01