Show - Cisco 1120 Installation Manual

Appendix C Command Reference
Usage Guidelines
Use the set time command to set the timezone, current date, and current time. Subsequent prompts take
you through the process. For more information, see
You can also use the set time command to enable an NTP server to synchronize the CSACS 1120. You
can configure one or more NTP servers by separating each NTP IP address entry with a space. For more
information, see
page
Example
The following command initiates the system time setting procedure:
set time
set timeout
To set the period, in minutes, after which the serial console will time out, use the set timeout command:
set timeout
Syntax Description
This command has a single argument: the number of minutes before timing out. If you enter the
command with no argument, the system prompts you for a value in minutes.
Example
The following command establishes a serial console timeout after10 minutes:
set timeout 10

show

To show the version of the CSACS 1120, system load status, ACS service status, IP configuration,
system time, and NTP settings, CSACS 1120 hostname, DNS domain, and timeout value, use the show
command:
show
Syntax Description
This command has no arguments or keywords.
Example
The following command lists CSACS 1120 information:
show
OL-19455-01
Setting the System Time and Date with NTP
C-7.
[ ]
minutes
Setting the System Time and Date
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
Manually.
and the command reference
Commands
ntpsync,
C-13