Connecting To The Ac Power Source; Connecting Cables - Cisco CiscoWorks WLSE 1130-19 Installation And Configuration Manual

Chapter 2 Installing WLSE 1130-19 Hardware

Connecting to the AC Power Source

Warning

Connecting Cables

Step 1
Step 2
Warning
78-16778-01
This equipment must be grounded. Never defeat the ground conductor or
the equipment in the absence of a suitably installed ground conductor.
the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available. Statement 1024
Connect the AC power receptacle to the AC power source with the provided power
cable.
Use unshielded twisted pair (UTP) copper wire Ethernet cable, with standard
RJ-45 compatible plugs, to connect the WLSE to the network.
To connect the cables, follow these steps:
Plug the network connection into the Ethernet 0 port. See
for the location of the Ethernet 0 port
Connect a console to the console/serial port using the supplied serial cable and, if
necessary, the DB-9-to-RJ-45 console adapter. See
location of the serial port.
Do not work on the system or connect or disconnect cables during periods of
lightning activity. Statement 1001
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Installing WLSE 1130-19 Hardware
operate
Figure 1-2 on page 1-5
Figure 1-2 on page 1-5
Contact
for the
2-25