Cisco 1120 Installation Manual page 66

Initial Configuration
Step 16 The following prompts appear only if you set a static IP address manually. Otherwise the following
message appears:
No change to the configuration.
Accept network setting [Yes]
a. To specify the CSACS 1120 IP address, at the
address, and press Enter.
At the
b.
c. At the
At the
d.
to use (separate each by a single space), and press Enter.
Note
Result: The console displays:
IP Address is reconfigured.
At the
e.
Result: The console displays:
New ip address is set.
Default gateway is set to xx.xx.xx.xx
DNS servers are set to: xx.xx.xx.xx xx.xx.xx.x x.
f. At the
Result: The IP address for the appliance will be set.
At the
g.
Tip
h. At the
connected to the , and press Enter.
Result: If successful, the system displays the ping statistics and displays the Test network
connectivity prompt.
If network connectivity is validated in the previous two steps, at the
i.
[Yes]:
Tip
If the settings appear correctly, at the
Step 17
press Enter.
Result: The console displays:
Current Date Time Setting:
Time Zone: (GMT -xx:xx) XXX Time
Date and Time: mm/dd/yyyy
NTP Server(s): NTP Synchronization Disabled.
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
3-20
Chapter 3
Subnet Mask [xx.xx.xx.xx]:
Default Gateway [xx.xx.xx.xx]:
DNS Servers [xx.xx.xx.xx]:
If you do not intend to use a DNS server, enter the IP address of the CSACS 1120 at the
[
Servers xx.xx.xx.xx
server, you must respond to all prompts for hostname or IP address only with an IP address.
Confirm the changes? [Yes]:
Accept network setting:
Test network connectivity [Yes]:
This step executes a ping command to ensure the connectivity of the .
Enter hostname or IP address:
prompt, enter , and press Enter.
N
The system continues to provide you with the opportunity to test network connectivity until you
answer no. This means that you can correct network connections or retype the IP address.
Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2
IP Address [xx.xx.xx.xx]:
prompt, enter the subnet mask value, and press Enter.
prompt, enter the default gateway value, and press Enter.
prompt, enter the address of any DNS server that you intend
] prompt. If you do not configure the CSACS 1120 to use a DNS
prompt, enter , and press Enter.
Y
prompt, enter , and press Enter.
Y
prompt, enter
prompt, enter the IP address or hostname of a device
Accept network setting [Yes]:
prompt, enter the IP
, and press Enter.
Y
Test network connectivity
prompt, enter , and
Y
DNS
OL-19455-01