Installing The Slide Rails Into A Rack With Square Holes; Setting The Multi-Pin Adapters For The Rack Type; Installing And Securing The Slide Rails In A Rack - Cisco 1120 Installation Manual

Mounting the CSACS 1120 Series Appliance in a 4-Post Rack
•
Each rail consists of three pieces that slide to extend the rail to its full length. To access the features of
Note
the innermost piece, such as the release levers, you must grasp the end of the innermost piece and pull
it firmly out of the piece that contains it.
Proceed to the next section,
continue the installation process.

Installing the Slide Rails into a Rack with Square Holes

This section contains:
•
•

Setting the Multi-Pin Adapters for the Rack Type

The multi-pin adapters allow the slide rails to be used in racks that have square mounting holes or round
mounting holes.
To set the adapters for the rack type:
On each slide rail, reverse the multi-pin adapter position to match the rack-mounting hole type, if
Step 1
necessary. Remove the multi-pin adapter by rotating the swivel lock upward, pressing the mounting pins
together, and then pulling the adapter from the multi-pin bracket.
Step 2 Install the multi-pin adapter by pressing the pins together while inserting the adapter into the bracket.
The multi-pin adapter must be fully locked in the bracket. Ensure that both mounting pins on the
multi-pin adapter are fully engaged in the multi-pin bracket, then lock the multi-pin adapter in place
using the swivel lock.
Repeat Steps
Step 3
To lock the adapters in place:
Step 4
a.
Note
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
3-4
For racks with round holes, you use rack screws, rather than the multi-pin adapters. Rack screws are
not included in the installation kit.
Installing the Slide Rails into a Rack with Square Holes, page
Setting the Multi-Pin Adapters for the Rack Type, page 3-4
Installing and Securing the Slide Rails in a Rack, page 3-5
1 and 2 for both ends of each slide rail.
Rotate the swivel lock to the up position. position, as shown in the illustration at the left in
Figure 3-2. Press the pins together and insert the rack-mounting end of the multi-pin adapter through
the corresponding holes in the bracket.
Insert the adapter into the bracket with the slotted pin in the up position, as shown in
Chapter 3 Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2
Figure 3-2 shows you the release levers.
3-4, to
Figure 3-2.
OL-19455-01