Setting Up A Gui Administrator Account - Cisco 1120 Installation Manual

Initial Configuration

Setting Up a GUI Administrator Account

After initial installation or re-imaging, unless you specified a GUI administrator account during the
initial configuration using the setup script, only one administrator account exists: the CLI administrator
account. This account allows access only through a serial console log in and CLI commands.
If you specified a GUI administrator account when prompted for one by the setup script, a GUI
administrator account exists. However, before the designated GUI administrator user can use this
account, you must unlock it by entering the unlock guiadmin command.
You can also set up an additional GUI administrator account that can access the CSACS 1120.
To set up an initial web GUI account:
Step 1 Log in as the CLI administrator.
If a GUI administrator account was specified during initial configuration using the setup script, enter the
Step 2
unlock guiadmin command to unlock the GUI administrator account:
unlock guiadmin < Admin > < Password >
where Admin is the name of the GUI administrator account and Password is the password for the account.
If no GUI administrator account has been set up or you want to add additional GUI administrator
Step 3
accounts, at the command prompt, enter:
add guiadmin
Result: The console displays:
Adding new GUI Administrator
Note! All ACS services will be restarted.
GUI Administrator password policy is:
Password must be at least 4 character(s) long.
At the
Step 4
press Enter.
At the
Step 5
Note
At the
Step 6
Result: The console displays:
GUI Administrator added successfully.The new GUI administrator account is not usable until
you unlock it by entering the unlock guiadmin command.
Now, you can now use the GUI administrator account to remotely access the ACS GUI running on the
CSACS 1120.
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
3-22
Chapter 3
Enter new GUI administrator name:
prompt, enter the new password, and press Enter.
Enter new password:
The password can only contain a maximum of 32 characters and a minimum of 4 characters.
Enter new password again:
Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2
prompt, enter the new GUI administrator name, and
prompt, enter the new password again, and press Enter.
OL-19455-01