Connecting Cables - Cisco IP/TV 3400 Series User Manual

Chapter 3 Installing the IP/TV Server

Connecting Cables

Step 1
Step 2
Step 3
Step 4
Figure 3-7 Cisco IP/TV 3425 and 3425A Servers—Front Panel Connectors
SCSI LVD only
CONSOLE ETHERNET 0 ETHERNET 1 SCSI LVD ONLY
Ethernet 1
(not supported in IP/TV)
Ethernet 0
Console
(not supported in IP/TV)
Step 5
OL-4467-01
To connect network, monitor, keyboard, and mouse cables to the Cisco IP/TV
Server, follow these steps:
Plug the monitor cable into the onboard video port on the IP/TV Server back
panel.
Connect the other end of the monitor cable to a monitor.
Connect a keyboard and mouse to the keyboard port and mouse ports on the IP/TV
Server back panel.
For network connections, insert a Category 5 UTP cable into the
Ethernet port labeled "Ethernet 0" on the IP/TV Server front panel. (See
Figure 3-7.) When active, the System LED on the left front corner of the Cisco
IP/TV 3400 Series Server is lit.
The console port and Ethernet port 1 are not used by Cisco IP/TV 3400
Note
Series Servers.
SLOT 0
Slot 0
Connect the other end of the network cable to a hub or switch in your network.
Installing Cisco IP/TV 3425 and 3425A Server Units
SLOT 1
Slot 1
Cisco IP/TV 3400 Series Servers User Guide
3-7