Server Replacement; Remove The Server From The Rack - Lenovo ThinkSystem SR630 V3 User Manual

Note: The Lenovo XClarity Controller can place the server in a standby state as an automatic response to a
critical system failure.
• Start an orderly shutdown using the operating system (if supported by your operating system).
• Press the power button to start an orderly shutdown (if supported by your operating system).
• Press and hold the power button for more than 4 seconds to force a shutdown.
When in a standby state, the server can respond to remote power-on requests sent to the Lenovo XClarity
Controller. For information about powering on the server, see

Server replacement

Follow instructions in this section to remove and install the server.

Remove the server from the rack

Follow instructions in this section to remove the server from the rack.
S036
18 - 32 kg (39 - 70 lb)
CAUTION:
Use safe practices when lifting.
R006
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
CAUTION:
• Potential stability hazards exist. The rack might tip over and cause serious personal injury.
• Before extending the rack to the installation position, read the
Do not put any load on the slide-rail mounted equipment in the installation position. Do not leave
the slide-rail mounted equipment in the installation position.
About this task
Attention:
• Read "Installation Guidelines" on page 51
work safely.
"Power on the server" on page
32 - 55 kg (70 - 121 lb)
and "Safety inspection checklist" on page 52
Chapter 5
68.
"Installation Guidelines" on page
to ensure that you
.
Hardware replacement procedures
51.
69