Cooling Module - Lenovo ThinkSystem SR630 V3 User Manual

a. Fully loosen the Torx T30 nuts on the cold plate assembly and radiator.
b. Rotate the anti-tilt wire bails inward.
c. Carefully lift the LACM from the processor sockets by the module handle (LACM heat sink
bracket). If the LACM cannot be fully lifted out of the socket, further loosen the Torx T30 nuts
and try lifting the LACM again.
Step 8. Place the LACM on the shipping tray.
Step 9. If there is any old thermal grease on the processors and the cold plates, gently clean the top of the
processors and the cold plates with an alcohol cleaning pad.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install the Lenovo Neptune(TM) liquid assisted cooling module
Follow instructions in this section to install the Liquid Assisted Cooling Module (LACM).
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do no
attempt to remove or install it without proper training and qualification.
About this task
Safety information for liquid detection sensor module cable
S011
CAUTION:
Sharp edges, corners, or joints nearby.
Attention:
.
Chapter 5 Hardware replacement procedures
143