Server Replacement; Remove The Server From The Rails - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Figure 114. Installing the RAID flash power module and bracket assembly onto the chassis
Step 3. Connect the RAID flash power module cable to the RAID adapter. See "M.2 adapter, intrusion
switch, and RAID flash power module" on page 66.
Note: Make sure that the RAID flash power module cable connector is fully seated in place as
illustrated when being plugged into the connector on the 9350-8i or 9350-16i RAID adapter.
After this task is completed
Complete the parts replacement. See "Complete the parts replacement" on page 217.

Server replacement

Follow instructions in this section to remove the server from the rails or install it into the rails.

Remove the server from the rails

Follow instructions in this section to remove ST250 V2 from the rails.
.
Chapter 4 Hardware replacement procedures
191