Remove The 7Mm Rear Drive Assembly - Lenovo ThinkSystem SR630 V3 User Manual

Step 6. Align the pins on the 2.5-inch rear drive cage with the corresponding hole and slot in the chassis.
Then, lower the 2.5-inch rear drive cage into the chassis until it is fully seated.
Figure 139. 2.5-inch rear drive cage installation
Step 7. Connect the cables to the processor board or expansion slots. See
routing" on page
After you finish
1. Reinstall the drives or drive fillers into the 2.5-inch rear drive cage. See
drive" on page 117.
2. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube

Remove the 7mm rear drive assembly

Use this information to remove the 7mm rear drive assembly.
About this task
The following illustrates how to remove the 7mm rear drive assembly.
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
ThinkSystem SR630 V3 User Guide
202
249.
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 52
68.
Chapter 6 "Internal cable
"Install a 2.5/3.5-inch hot-swap
246.
to ensure that you