Server Replacement; Remove The Server From Rack - Lenovo ThinkSystem SR665 V3 User Manual

Power button location and power LED are specified in:
• Chapter 2 "Server components" on page 11
• "Troubleshooting by system LEDs and diagnostics display" on page 198
To place the server in a standby state (power status LED flashes once per second):
Note: The Lenovo XClarity Controller can place the server in a standby state as an automatic response to a
critical system failure.
• Start an orderly shutdown using the operating system (if supported by your operating system).
• Press the power button to start an orderly shutdown (if supported by your operating system).
• Press and hold the power button for more than 4 seconds to force a shutdown.
When in a standby state, the server can respond to remote power-on requests sent to the Lenovo XClarity
Controller. For information about powering on the server, see

Server replacement

Follow instructions in this section to remove and install the server.
• "Remove the server from rack" on page 49
• "Install the server to rack" on page 52

Remove the server from rack

Follow instructions in this section to remove the server from the rack.
S036
18 - 32 kg (39 - 70 lb)
CAUTION:
Use safe practices when lifting.
R006
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
CAUTION:
• Potential stability hazards exist. The rack might tip over and cause serious personal injury.
"Power on the server" on page
32 - 55 kg (70 - 121 lb)
.
Chapter 5 Hardware replacement procedures
48.
49