Step 3.
Press the two latches on both ends at the same time, and carefully lift the riser cage out of the
chassis by two latches.
Figure 184. Removing the riser bracket
Step 4.
Open the retention latch and remove the serial port module from the riser bracket.
Figure 185. Removing the riser bracket
a.
Open the retention latch.
b.
Remove the serial port module from the riser bracket.
Step 5.
(Optional) If you need to replace the serial port bracket, use a 5 mm wrench to disassemble the
serial port cable from the bracket.
ThinkSystem SR630 V3 User Guide
218