Cable routing for M.2 SATA/NVMe x4 backplane
From
M.2 power
1
M.2 signal
2
Note: The illustrations above take the M.2 drive assembly in the 2.5/3.5-inch drive chassis for an example. In
the 16-EDSFF drive chassis, the cable routing method remains the same.
M.2 backplane to SFF RAID adapters
See this section to understand the cable routing between an M.2 drive backplane and an SFF RAID adapter.
To
M.2 power connector
1
7mm/M.2 signal port on the processor board (for SATA
2
signal)
PCIe 8 (for NVMe signal, connected when two
3
processors are installed)
PCIe 1 (for NVMe signal, connected when one
4
processor is installed)
Chapter 6
.
Internal cable routing
269