Step 4.
Position the riser assembly on the chassis. Align the plastic clip and two pins on the bracket with
the guide pin and two holes on the chassis, and align the riser card with the riser slot on the system
board assembly. Then, carefully press the riser assembly straight down into the slot until it is fully
seated.
Figure 178. Riser assembly installation
After you finish
Complete the parts replacement. See
Demo video
Watch the procedure on YouTube
Security bezel replacement
Use this information to remove and install the security bezel.
Note: The security bezel is available on some models.
Remove the security bezel
Use this information to remove the security bezel.
About this task
Attention:
"Complete the parts replacement" on page
246.
.
Chapter 5
Hardware replacement procedures
213