Install A Hot-Swap Power Supply Unit - Lenovo ThinkSystem SR630 V3 User Manual

Step 3. Press the release tab toward the handle and carefully pull the handle at the same time to slide the
hot-swap power supply unit out of the chassis.
Figure 82. Hot-swap power supply removal
After you finish
1. Install a new power supply unit or install the power-supply-unit filler to cover the power supply bay. See
"Install a hot-swap power supply unit" on page
Important: To ensure proper cooling during normal server operation, both power supply bays must be
occupied. This means that each bay must have a power supply unit installed; or one has a power supply
unit installed and the other has a power-supply-unit filler installed.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube

Install a hot-swap power supply unit

Use this information to install a hot-swap power supply unit.
About this task
The following describes the information that you must consider when installing a power supply unit:
• If the power supply unit to be removed is the only one installed, the power supply unit is not hot-
swappable. Before removing it, you must turn off the server first. To support redundancy mode or hot-
swap, install an additional hot-swap power supply unit.
• If you are replacing the existing power supply with a new power supply:
– Use Lenovo Capacity Planner to calculate the required power capacity for what is configured for your
server. More information about Lenovo Capacity Planner is available at:
https://datacentersupport.lenovo.com/solutions/lnvo-lcp
– Ensure that the devices that you are installing are supported. For a list of supported optional devices for
the server, go to:
https://serverproven.lenovo.com
ThinkSystem SR630 V3 User Guide
128
128.