Lenovo ThinkSystem SR630 V3 User Manual page 246

the processor external cap out from the processor socket on the new system board assembly, and install the
external cap on the processor socket on the removed system board assembly.
If you are planning to recycle the system board assembly, follow the instructions in
disassembling for recycle" on page 483
Demo video
Watch the procedure on YouTube
Install the processor board
Follow instructions in this section to install the processor board.
About this task
A processor board provides different connectors or slots to connect different components or peripherals of
the system for communication. The board and the supporting metal sheet constitute a base for the system
board assembly. If the processor board fails, it must be replaced.
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the system board assembly to any unpainted
surface on the outside of the server. Then, take the processor board out of the package and place it
on a static-protective surface.
Figure 198. The processor board
Step 2. Install the system I/O board, see
Step 3. Install the Firmware and RoT Security Module, see
on page 225.
ThinkSystem SR630 V3 User Guide
236
for compliance with local regulations.
and "Safety inspection checklist" on page 52
68.
"Install the system I/O board" on page
Appendix A "Hardware
231.
"Install the Firmware and RoT Security Module"
to ensure that you