Lenovo ThinkSystem SR630 V3 User Manual page 210

About this task
The following illustrates how to install the 2.5-inch rear drive assembly.
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the 2.5-inch rear drive cage to any unpainted
surface on the outside of the server. And then, take the 2.5-inch rear drive cage out of the package
and place it on a static-protective surface.
Step 2. Gently press and hold the tab on the 2.5-inch rear drive cage as shown and remove the air baffle
from the 2.5-inch rear drive cage.
Figure 136. Air baffle removal
a. Press the tab on one side to disengage the air baffle.
b. Lift the air baffle to remove it from drive cage.
Step 3. Align the rear backplane with the 2.5-inch rear drive cage and lower it into the 2.5-inch rear drive
cage.
ThinkSystem SR630 V3 User Guide
200
and "Safety inspection checklist" on page 52
68.
to ensure that you