Expansion Card For Devicenet - Pilz PMCtendo DD5 Operating Manual

6 Wiring
6.8 Expansion cards
6.8.4

Expansion card for DeviceNet

6- ][Verdr_DeviceNet_protego_D Expansion card for DeviceNet
Connector X15
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
6-64
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
When installing and wiring please refer to the "DeviceNet Specification,
Volume I, II, Version 2.0", publishedby ODVA. This containsinformation
on:
Cable selection

Cable routing

Shielding

Bus connectors

Bus termination

Runtimes

Correct wiring:
Stub lines of 0 ... 6 m are permitted on each device.

Branches within stub lines are permitted.

Voltage to the devices can be supplied via the bus

INFORMATION
Please note:
The signal lines on the first and last subscribers should use con-
nectors fitted with terminating resistors in accordance with the
"DeviceNet Specification, Vol I, Chapter 9" (from Version 2.0,
1997): 121 Ohm, 1% metal film, 1/4 Watt.
Connector pin assignment
Pin Designation
1 V-
2 CAN_L
3 SHIELD
4 CAN_H
5 V+
5-pin Combicon plug-in connector in accordance with the DeviceNet specification
Description
Supply voltage (-)
DeviceNet connection (low signal)
Cable shield connection
DeviceNet connection (high signal)
Supply voltage (+)