Expansion Cards - Pilz PMCtendo DD5 Operating Manual

4 Function description
4.4

Expansion cards

4.4.1 Expansion card I/O-14/08
4- Expansion cards 4400 Expansion cards 4.4
4- ][Funktion_Erw_I_O_14_8_protego_D Expansion card I/O-14/08
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
The expansion card I/O-14/08 is available as an accessory.
Functions:
14 additional digital inputs and 8 digital outputs

The function of the inputs and outputs can be configured in the com-

missioning software.
The inputs initiate the motion tasks that are stored in the servo ampli-

fier.
The outputs signal the status of the integrated position controller to

the higher level control system.
The functions of the inputs and outputs correspond to the functions

that can be assigned to the digital inputs and outputs on connector
X3 of the servo amplifier.
The inputs and outputs are isolated from the servo amplifier through

optocouplers.
Fig. 4-11: Front view of expansion card I/O-14/08
LEDs:
LED Description
Green 24 V supply voltage is present
Red Fault on the expansion card's outputs (overload and/or short
circuit)
Enter the motion block number (example)
Motion block A7 A6
number
Binary 1010 1 0
1110
Decimal 74 1 128 -
The functions can be configured in the commissioning software. The ta-
ble overleaf shows the default settings.
A5 A4 A3 A2
1 0 1 1
32 - 8 4
A1 A0
1 0
2 -
4-35