Enable Sata Raid In System Bios - SOLTEK SL-B5A-FG Manual

SL-B5A-FG / B5A-FGR

5-1 Enable SATA RAID in System BIOS

To enable SATA RAID controller, boot the system and watch for the
following initial screen to appear:
Inrel (R) Application Acceleration RAID Option ROM vxxxxxxx
Copyright (C) 2003-04 Intel Corporation. All right reserved.
RAID Volumes:
None defined.
Physical Disks:
Port Drive Model
0 ST380023AS
2 Maxtor 6Y120M0
Press <CTRL-I > to enter Configuration Utility..
(The above message indicates that the SATA hard disks on board are detected by the
RAID BIOS.)
As soon as the above screen appears, press < Delete > key
( n o t < C T R L - I > k e y ) to enter CMOS BIOS Setup. Choose "Advanced
( n o t < C T R L - I > k e y )
BIOS Features" and "IDE Configuration" to configure S-ATA as RAID.
IDE Configuration
ATA/IDE Configuration
Configure SATA as
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Third IDE Master
Third IDE Slave
Hard Disk Write Protect
Disabled
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
S-ATA Detection Delay
Configure SATA As:
This item allows you to configure SATA mode
Choices: IDE;
RAID (for ICH6R only): Supporting RAID0 or 1 mode
AHCI: If AHCI is chosen, it allows you to enable the Stagger Spinup Support
Serial #
XXXXXXXXX
XXXXXXXXX
IDE Configuration
and take all hard disks on board as master.
Chapter 5 ICH6R SATA RAID
Size Type/Status(Vol ID)
115.0GM Non-RAID Disk
114.0GM Non RAID Disk
Enhanced
RAID
Hard Disk
Hard Disk
CD-ROM
Not Detected
Not Detected
Not Detected
35
Host & Device
Enabled
85
Help Item