4-6.3.2 Ide Configuration - SOLTEK SL-B5A-FG Manual

SL-B5A-FG / B5A-FGR

4-6.3.2 IDE Configuration

Choose "IDE Configuration" in "Advanced BIOS Features" and press
<Enter>. The following sub-screen will appear for IDE Devices
configuration:
IDE Configuration
ATA/IDE Configuration
Configure SATA as
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Third IDE Master
Third IDE Slave
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
S-ATA Detection Delay
4-6.3.2-1 ATA/IDE Configuration
ATA/IDE Configuration
Allows you to configurare IDE device mode.
Choices: Disabled; Compatible; Enhanced
Disabled: If disabled, no Primary/Secondary IDE mode will be presented
for configuration.
Compatible: If Compatible selected, Legacy IDE Channels will be
presented for configuration.
Enhanced: If Enhanced selected, Configure SATA as mode will
be presented for configuration.
Configure SATA As:
This item allows you to configure SATA mode
Choices: IDE;
RAID (for ICH6R only);
AHCI: If AHCI is chosen, it allows you to enable the Stagger Spinup Support
IDE Configuration
and take all hard disks on board as master.
Enhanced
IDE
Hard Disk
ATAPI CDROM
Not Detected
Not Detected
Not Detected
Not Detected
Disabled
35
Host & Device
Enabled
56
Chapter 4 BIOS Setup
Help Item