To Create Disk Array - SOLTEK SL-B5A-FG Manual

SL-B5A-FG / B5A-FGR

5-3 To Create Disk Array

(5-3-1) When you press <Enter> on the "1. Create RAID Volume" bar,
the following screen shows up. Enter a name for the volume to be
created.
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive and
[ ]-Change [Tab] - Next
(5-3-2) Next, press <Tab> key to jump to RAID Level bar and press
Arrow key to select the RAID mode.
Choose the RAID level best suited to your usage model.
RAID0(Stripe) - Create a volume where equal portions of the volume
RAID1(Mirror)) - Create a volume where a redundant copy of the data is
[ ]-Change [Tab] - Next
[ Create Array MENU ]
Name:
RAID Level:
Strip Size:
Capacity:
Create Volume
cannot contain special characters.
[ESC] - Previous Menu [Enter] - Select Menu
[ Create Array MENU ]
Name:
RAID Level:
Strip Size:
Capacity:
Create Volume
[ Help ]
are spread accross all the disks. This creates a volume
with higher performance by accessing all disks at once.
stored on each disk. This creates a volume protected
from a single hard disk failure.
[ESC] - Previous Menu [Enter] - Select Menu
Chapter 5 ICH6R SATA RAID
RAID Volume 1
RAID1(Mirror)
128KB
228.9GB
[ Help ]
RAID Volume 1
RAID1(Mirror)
128KB
228.9GB
87