Floppy Drive Installation - SOLTEK SL-B5A-FG Manual

SL-B5A-FG / B5A-FGR

2-6 Floppy Drive Installation

To install FDC on barebone system, you should connect the end with
Signal Swap of the floppy drive cable to floppy drive, and connect the
other end to the floppy drive connector (FDC) on Mainboard.
PCIEX
This kind of cable is dedicated for Mini-barebone
system because the ribbon can be bundled up and
will not block the air flow in the barebone cabinet.
A dedicated cable supporting only one floppy drive
is dedicated for the Mini-barebone System.
SATA4
SATA3
SATA2
SATA1
Pin 1 (to Red Line)
34-pin FDC cable
(Dedicated for Barebone)
Signal Swap End
To Floppy Drive
Chapter 2 Hardware Setup
Floppy Drive Connector:
Orient the red line of the
Floppy Flat Cable to Pin1.
Red line
To mainboard
23