To Install Sata Ahci Hard Disks Driver; To Enable Ahci Function In Bios Setup - SOLTEK SL-B5A-FG Manual

SL-B5A-FG / B5A-FGR

5-5 To Install SATA AHCI Hard Disks Driver

SATA-AHCI hard Disks system requires AHCI driver support. User should
install the AHCI driver as illustrated below.

5-5-1 To Enable AHCI Function in BIOS Setup

Enter CMOS BIOS Setup and choose "Advanced BIOS Features" and
"IDE Configuration" to configure S-ATA as AHCI.
IDE Configuration
ATA/IDE Configuration
Configure SATA as
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Third IDE Master
Third IDE Slave
Hard Disk Write Protect
Disabled
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
S-ATA Detection Delay
Configure SATA As:
This item allows you to configure SATA mode
Choices: IDE;
RAID (for ICH6R only): Supporting RAID0 or 1 mode
AHCI: If AHCI is chosen, it allows you to enable the Stagger Spinup Support
IDE Configuration
and take all hard disks on board as master.
Chapter 5 ICH6R SATA RAID
Enhanced
AHCI
Hard Disk
Hard Disk
CD-ROM
Not Detected
Not Detected
Not Detected
35
Host & Device
Enabled
93
Help Item