Table of Contents
Advertisement
K8AV2-R / K8AV2-RL
5-2 Enable SATA-RAID Interface with System BIOS
(1) Boot the K8AV2-R/K8AV2-RL system and watch for the following
initial screen to appear:
VIA Technologies, Inc. VIA VT6420 RAID BIOS Setting Utility v (xxx)
Copyright (C) VIA Technologies, Inc. All right reserved.
Scan Devices, please wait ....
Press < Tab > key into User Windows!
Channel 0 Master: ST3120023AS
Channel 1 Master: ST380023AS
(The above message indicates that the SATA hard disks on board are
detected by the RAID BIOS.)
(2) As soon as the above screen appears, press < Delete > key (not the
<Tab> key) to enter CMOS BIOS Setup. Choose "Integrated
Peripheral" and "VIA OnChip IDE Device". As soon as you click on
the "VIA OnChip IDE Device", a list of events appears for you to
configure their values. Choose "Enabled" for the "OnChip SATA" so
as to enable the SATA RAID interface.
VIA OnChip IDE Device:
To press< Enter > on VIA OnChip IDE Device will reveal the following
item(s).
OnChip SATA To enable/disable the on-chip SATA interface.
SATA Mode If OnChip SATA is enabled, this item is also en-
On-Chip IDE Channel
-----------
-----------
abled to support RAID mode only (SATA mode
not supported).
Choice: RAID
---------------------
10/11
86
Advertisement
Table of Contents
