Enable Sata-Raid Interface With System Bios - SOLTEK SL-B9D-FGR Manual

SL-B9D-FGR

5-2 Enable SATA-RAID Interface with System BIOS

(1) Boot system and watch for the following initial screen to appear:
VIA Technologies, Inc. VIA VT6420 RAID BIOS Setting Utility v (xxx)
Copyright (C) VIA Technologies, Inc. All right reserved.
Scan Devices, please wait ....
Press < Tab > key into User Windows!
Channel 0 Master: ST3120023AS
Channel 1 Master: ST380023AS
(The above message indicates that the SATA hard disks on board are
detected by the RAID BIOS.)
(2) As soon as the above screen appears, press < Delete > key (not the
<Tab> key) to enter CMOS BIOS Setup. Choose "Integrated
Peripheral" and "VIA OnChip IDE Device". As soon as you click on
the "VIA OnChip IDE Device", a list of events appears for you to
configure their values. Choose "Enabled" for the "OnChip SATA" so
as to enable the SATA RAID interface.
OnChip SATA
SATA Mode
IDE DMA transfer access
OnChip IDE Channel10
OnChip IDE Channel11
IDE Prefetch Mode
Primary Master PIO
Primary Slave PIO
Secondary Master PIO
Secondary Slave PIO
Primary Master UDMA
Primary Slave UDMA
Secondary Master UDMA
Secondary Slave UDMA
IDE HDD Block Mode
OnChip SATA To enable/disable the South Bridge SATA interface.
SATA Mode To select RAID so as to set up RAID system.
Chapter 5 VIA VT8237 RAID Setup
VIA OnChip IDE Device
Enabled
RAID
Enabled
Enabled
Enabled
Enabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Enabled
83
Item Help