4-6.7.3 Change Supervisor Password - SOLTEK SL-B5A-FG Manual

SL-B5A-FG / B5A-FGR

4-6.7.3 Change Supervisor Password

This option allows you to set a new Supervisor password for the system:
1. Choose "Change Supervisor Password" in the "BIOS Security Fea-
tures" and press <Enter>. Then the following message appears:
2. The first time you run this option, enter your password up to 6 char-
acters and press <Enter>. (The screen does not display the entered
characters.)
3. After you enter the password, the following message appears, prompt-
ing you to confirm the password:
4. Enter the same password "exactly" the same as you have just typed
to confirm the password and press <Enter>.
5. The following message appears to confirm the new password setup.
6. Then press any key to continue your CMOS Setup. To save the pass-
word setup, you should press "Save Changes and Exit" and choose
"OK" to exit and save setup.
7. If you enter a new password into the box, you will be using this new
password after you have finished and saved this new setup. Instead,
if you press <Enter> before you enter any new password into the
instruction box, another message box appears, telling you that you
have disabled the Supervisor Password. That means, no password
is set for either entering BIOS Setup or system:
User Access Level Allows you to set four different Access Levels when
Note: "User Access Level" and "Password Check" will appear when "Su-
pervisor Password" has been set.
[ Enter new supervisor password ]
[ Confirm New Password ]
[ Password installed ]
[ Password uninstalled ]
Supervisor Password has been set.
Choices: Full Access; Limited; View Only; No Ac-
cess
[OK]
[OK]
78
Chapter 4 BIOS Setup