SOLTEK SL-B5A-FG Manual page 14

SL-B5A-FG / B5A-FGR
5. As soon as the Cover and Cap is lifted up, place down the 775 CPU gently into 775
Socket with Pad1 matching Socket Pin1.
6. When you have made sure the 775-CPU is properly laid down, you should now return
the Metal Cover to Socket so as to fix down the CPU.
7. After returning the Metal Cover to Socket, pull back the Socket Lever to Socket until it
gets back to the latch.
8. Since the Metal Cover is returned to Socket, use a fingertip to lift and remove the
protective Cap for the Cooling Fan installation.
(The Cap is lifted up away from the
Cover and can be removed now.)
(Attention: Never remove this Protective
Cap if CPU is not in Socket.)
9. CPU is installed, Metal cover fixed to socket, Protective Cap removed, we should install
CPU Cooling Fan now.
( Cooling Fan
10. Insert the 4 Fan Supporters into the Support Holes on board, and then connect the Fan
Power cable to the Fan Connector on board.
(775 Cooling Fan
Supporter)
(This yellow triangle on CPU
denotes Pad1of CPU.)
(Lever returned to Latch)
(CPU installed, Metal Cover fixed to Socket, and Protective
Cap removed, we should install CPU Cooling Fan now.)
Support Hole)
CPU Fan and Fan Power cable are set up.
Chapter 2 Hardware Setup
(This triangle on socket denotes
Socket Pin1 location.)
(The Metal cover)
( Cooling Fan
Support Hole)
(The Fan cable is
connected to Fan
connector on board.)
17
(The 775 CPU)
(The 775-Socket)