Check Housing Parts (Visual Inspection) - Honeywell enCore Series Manual

10

10.3.7 Check housing parts (visual inspection)

General
NOTICE AVIS
The housing may only be repaired by Honeywell. Explosion-proof
equipment not repaired by the manufacture may be not used again
Le boîtier ne peut être réparé que par Honeywell. Les équipements an-
tidéflagrants qui ne sont pas réparés par le fabricant ne peuvent plus être
utilisés.
Prerequisite(s)
Maintenance work is performed on the device.
l
Unusual changes at the place of use.
l
Steps
1. Check all housing parts (including built-in parts such as flow meter or
additional parts such as local display) for damage and loose components.
2. Tighten loose parts if existing. Set unscrewing locks in function and note the
result in the maintenance report or your documents.
Further procedure
If all components are undamaged and bolts and fasteners are in proper con-
l
dition the use until next maintenance is possible.
If damaged parts present inform Honeywell, disconnect the gas and power
l
supply and do not use the deviec until it has been repaired.
GasLab Q2
Maintenance, cleaning and repair
User Manual (N ) 269 of 315