Honeywell enCore Series Manual page 195

8
In the export value window SFB provides time related events under Basic system
time service time events. They can be used as input signal for time-controlled ac-
tions in other SFBs or AFBs. )
Special case: Trigger for a longer cycle duration is activated first
Event signals in a second rhythm are formed relative to a full minute and
event signals in a minute rhythm are formed relative to a full hour. For
example:
Every other minute e.g., 12:02:00 ... 12:04:00 ... 12:06:00 ..., etc.
Every 3 minutes e.g., 12:03:00 ... 12:06:00 ... 12:09:00 ..., etc.
This means that immediately after the device is restarted and until a
cyclic event signal is first triggered the time depends on the boot time
and may be shorter than the associated cycle. This special case can only
occur once immediately after the device is restarted.
Example: If the enCore device is switched on at 12:02:30 and the signals
Every other minute and
system time 12:03.00, the signal
subsequently at 12:04.00 is the signal
Update date and time (system time action)
The system time is the combination of the device time and date. You can update it
with the enSuite action "Update date and time" or on the operation panel
System display Time Service (System time and date)
The online help provides the necessary information. In the help window
under About enSuite >> Navigation >> Devices >> Device - actions >>
Update date and time.
GasLab Q2
Configuration and analysis software enSuite
Every 3 minutes are used as triggers, at
Every 3 minutes is formed and only
Every other minute formed.
(p. 128)
User Manual (N )
7.3.5
➪
195 of 315