Honeywell enCore Series Manual page 309

14
N
Network Time Protocol.
NTP for the high-precision time synchronization of enCore devices
with an NTP time server.
Note
Generated if a measurement violates a state defined by the user. The
start is logged in the logbook.
O
Operating mode
Different working states of the device during operation are known as
operating modes.
Operational calibration gas
short called calibration gas, is kept in a cylinder permanently con-
nected to the device and is an integral part of the instument. This is a
mixture of two or more components e.g. methane and carbon dioxide
with officially defined properties and is required for automatic cal-
ibration.
Ordinal number
or sequence number is an automatically assigned identification num-
ber for archived data. This is formed so that the very first archive entry
has the number 1. The number is incremented by one for each sub-
sequent entry.
P
Peak
The maximum deflection of a signal. In a chromatogram, every peak
represents a component.
PELV
PELV protective extra-low voltage systems which comply with DIN EN
60079-14: the power supply to generate PELVs must ensure that no
short-circuit is possible between the primary voltage and the extra-
low voltage and its connections. It has a safe electrical isolation point
(safety isolation transformer) and complies with IEC 61558-2-6. The
circuits are grounded. All bodies of electrical equipment must be con-
nected to a common grounding (and equipotential bonding) system.
GasLab Q2 User Manual (N )
Glossary
309 of 315