Honeywell enCore Series Manual page 136

7
Mechanisms to end exclusive access
The device has the following mechanisms to prevent the device accidentally being
blocked for further service activities:
Parameter Inactivity timeout
l
If there is inactivity, a user is automatically logged out after a parameterized
l
timeout (default is 120 min). Changes which have been made but not accep-
ted will be discarded.
The timeout takes effect for example if a user is logged in to the device
l
remotely and ends enSuite without logging out of the device beforehand.
l
( User, tab Parameter, Parameter Inactivity timeout)
(p. 211)
Automatic logout after an action has been carried out via enSuite
l
If an action is carried out in enSuite that requires a user to be logged in, the
l
user is automatically logged out at the end of the action. For example, this can
be after a parameterization or a firmware change has been transferred to the
device.
Logout remote user manually
l
For service activities on site, it is possible to manually log out a user who is
l
remotely logged in to the device. Please note that the parameter changes
made by the user who has been logged out will be discarded.
l
( System –
Closing enSuite or closing the connection to the device.
l
Logout
Access: Home –
GasLab Q2
User, action Logout remote
System – User
Fig. 7-26: Main display – User admin1 is logged on
User Manual (N )
GasLab Q2 operation panel and operation
➪
user).
General parameters
136 of 315