General Information; Disclaimer; Shipment Note; Initial Inspection - Honeywell HERMetic PRESS Operation And Service Manual

Table of Contents

Advertisement

4.1 Disclaimer

This manual is designed and written to provide
information with regard to the subject matter
involved. Enraf Tanksystem SA makes no
warranty, express or implied, that it is fit for any
purpose whatsoever; or to the absolute sufficiency
of the material presented.
Enraf Tanksystem SA assumes no responsibility
for any inaccuracies in reproduction or errors in
interpretation of any authority. Enraf Tanksystem
SA reserves the right to modify or amend this
manual, without prior notification, but Enraf
Tanksystem SA assumes no responsibility to
update or issue corrections.
4.2

Shipment note

The following parts should be included in the
shipment:
- 1 instrument;
- 1 Operation and Service Manual.
4.3

Initial inspection

Check the contents of the shipment for
completeness and note whether any damage has
occurred during transport. Carry out the "Initial
test before installing the instrument" to verify the
good functioning. If the contents are incomplete,
or if there is damage, do not use the device. A
claim should be filled with the carrier immediately,
and Enraf Tanksystem SA Sales or Service
organization should be notified in order to
facilitate the repair or replacement of the
instrument.
4.4

Documentation discrepancies

The design of the instrument is subject to
continuous development and improvement.
Consequently, the instrument may incorporate
minor changes in detail from the information
contained in the manual.
50420/PRESS/1001

4. General information

4.5
12 months after installation but max. 18 months
after delivery ex works.
The Vendor undertakes to remedy any defect
resulting from faulty design materials or
workmanship. The Vendor's obligation is
limited to the repair or replacement of such
defective parts by his own plant or one of his
authorized service stations. The Purchaser
shall bear the cost and risk of transportation
of defective parts and repaired parts supplied
in replacement of such defective parts.
This warranty does not apply to those items
which by their nature are subject to
deterioration or consumption in normal
service, and which must be cleaned, or
replaced on a routine basis.
When returned to Enraf Tanksystem SA
equipment must be contamination-free. If it is
determined that the Purchasers equipment is
contaminated, it will be returned to the
Purchaser at the Purchasers expense.
Contaminated equipment will not be repaired,
replaced, or covered under any warranty until
such time that the Purchaser decontaminates
the said equipment.
The Purchaser shall notify by fax, telex or in
writing of any defect immediately upon discovery,
specifying the nature of the defect and/or the
extend of the damage caused thereby.
Where no other conditions have been negotiated
between the Vendor and the Purchaser "General
Conditions 188" of United Nations shall apply.
Unauthorized repair or component replacement
by non original spare parts by the Purchaser will
void this guarantee and may impair the good
functioning of the instrument.
This warranty is expressly in lieu of any and all
other warranties and representations expressed
or implied, and all other obligations or liabilities on
the part of the Vendor (Enraf Tanksystem SA)
including but not limited to, the warranty of
merchantability or fitness for a particular purpose.
In no event shall Enraf Tanksystem SA be liable
for indirect, incidental or consequential loss or
4

Warranty

PRESS

Advertisement

Table of Contents
loading

Table of Contents