Dcc Channel - Network If - Alcatel-Lucent 1850 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
Figure 3-45 DCC channel - network IF
The DCC tab displays a list of the facility with DCC capability previously provided. The
list is basically made up of a radio button, an AID column and a DCCHNL column. It
displays the following parameters:
Click on one of the available radio button the NE Interface Details panel change the
fields according to the selection.
The Delete hyperlink allow to remove the selected item from the list.
The NE Interface Details panel contains the following parameters:
Access Identifier - Specifies the Access Identifier of the facility
•
DCCCHNL (DCC Channel) - Specifies whether the referred DCC is a Line DCC or a
•
Section DCC. The values are:
– LINE
– SECTION
Lower Layer Mode - Specifies the protocol used for the Layer 2 over the specified
•
DCC. The values are:
– LAPD - (LAPD Protocol to be supported on the Layer 2)
– PPP - (Point-to-Point Protocol to be supported on the Layer 2)
OSI Protocol - Determines if the OSI Protocol will be run on the addressed DCC or
•
not. The values are:
– N (OSI Protocol is disabled on the addressed DCC)
– Y (OSI Protocol is enabled on the addressed DCC)
Internet Protocol - Determines if the Internet Protocol will be run on the addressed
•
DCC or not. The values are:
............................................................................................................................................................................................................................................................
3 - 52
Xcom menu
8DG08763KAAA
Issue 1 February 2009